Remote Control - Mitsubishi WD-57833 Owner's Manual

4. TV Operation and Features 29
Remotecontrol,continued
23. F1-F4
For devices under NetCommand control:
Perform NetCommand "Learning" to assign your
choice of functions to the F1-F4keys.
For devices operating independently of
NetCommand: The F1-F4 keys work like the A,
B, C, D buttons on some cable boxes, satellite
receivers, and DVD players. Program the remote
control for your equipment and test the keys. See
Appendix D, "Programming the Remote Control."
25. (_ (PAUSE): F reezes a broadcast TV picture when
no Split Screen image is displayed. When Split
Screen is displayed, freezes the sub-picture.
Record/Playback Keys
Use any of these methods to enable the recording and
playback commands:
• Program the remote control for your DVR, VCR, or
DVD player/recorder and set the slide switch to VCR,
DVD, CABLE/SAT, or AUDIO as appropriate.
Perform NetCommand IR "learning" for the device.
For control of IEEE 1394 devices, see chapter 6,
"NetCommand."
Check HDMI devices for compatibility with the TV's
NetCommand for HDMI feature (see below).
24. _ (RECORD): Records with a VCR or DVR.
25. (_ (PAUSE): P auses a VCR, DVR, or DVD. See
above for use during TV viewing.
26. _ (STOP): S tops play of a VCR, DVR, or DVD.
27. _ (REVERSE): Rewinds a VCR. Reverse scans a
DVR or DVD.
28. @ (PLAY):Plays a VCR, DVR, or DVD.
29. _ (FORWARD): Fast forwards a VCR. Forward
scans a DVR or DVD.
NetCommand for HDMI Devices
The TV's remote may operate some functions of
compatible HDMI devices able to receive commands
through the HDMI cable. Test your equipment with the
TV's remote to find out which commands are sup-
ported. See below for commands that may be avail-
able, depending on the individual device. You can add
commands using NetCommand IR "learning" after con-
necting and placing IR emitters for the devices.
Press PLAY on the device itself to:
Turn on the TV if not already on
Switch to the device (no need to display the Input
Selection menu)
Begin play of the device
VCR, DVD, and DVR functions that may be available:
{_ 4 _ A Y CHA/V GUIDE
1_ _ ENTER Digits 0-9,_ F1(content)
_ _ (tocancel) ENTER MENU
Resetting the Remote Control
If the slide switch is set to TVand the TV does not
respond properly, reset the remote control.
1. Press and hold POWER for several seconds until the
button blinks twice and goes off.
2. Release the POWER button.
3. Press keys 0 0 9 3 5 and the POWER button will blink
twice when you finish entering the code. While
entering the code, pause for a moment between
each key press to ensure it is recognized.
Low-Battery Indicator
If you press a key and the POWER key blinks five times,
replace the remote control's batteries.
Care of the
Remote Control
= Use only alkaline batteries.
= Be within 20 feet of the equipment.
= Do not press two or more buttons at the same time
unless instructed to do so.
Do not allow unit to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only a
soft, lightly moistened cloth.
• Do not mix old and new batteries.