Oven Window; Oven Light - Maytag MER5775RAQ1 Use & Care Manual

Precision touch control 800 electric smoothtop
Table of Contents

Advertisement

Available languages

Available languages

Oven Door
Leveling Legs
Note: The oven door on a new range may feel "spongy"
when it is c osed. This is normal and will decrease with use.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or
other objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Oven Light
To replace oven light bulb:
1. When oven iscool, hold bulb cover
BuL_oovER
in place, then slide wire retainer
off cover. Note: Bulb cover
will fall if not held in place
while removing wire retainer.
2. Remove bulb cover and light
J
w, RE
bulb.
_'_
3. Replace with a 40-watt appliance
bulb.
4. Replace bulb cover and secure with wire retainer.
5. Reconnect
power to range. Reset clock.
Storage
Drawer
7
The storage drawer can be removed to allow you to clean
under the range.
To remove:
1. Empty drawer and pull out to the first stop position.
2. Lift up the front of the drawer.
3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the rails in the range.
2. Lift up the front of the drawer and gently push in to the
first stop position.
3. Lift drawer up again and push until drawer is closed.
Convenience
Outlet
(Canadian models only)
The convenience outlet is located on the lower left side of the
backguard. Be sure appliance cords do not rest on or near the
surface element. If the surface element
is turned on, the cord and outlet will be
damaged.
The convenience outlet circuit breaker
may trip if the small appliance plugged
into it exceeds 10 amps. To reset the
circuit breaker, press the switch located
on the lower edge of the backguard.
if ¸
CIRCUIT
BREAKER

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents