Stand Mixer Attachments; Mounting Attachments; Removing Attachments - KitchenAid KG25H0XER5 Instructions And Recipes Manual

STAND MIXER ATTACHMENTS
KitchenAid_'Attachments are designed to assure long life. The attachment
power shaft and hub socket are of a square design, to eliminate any possibility
of slipping during the transfer of power to the attachment. The hub and
shaft housing are tapered to assure a snug fit, even after prolonged use. All
KitchenAid _ Attachments require no extra power unit to operate them; the
power unit is built-in.
Hinged Hub Cover
Attachment Knob \
Attachment Hub Socket
Attachment Power Shaft
Attachment
Mounting Attachments
1. Make sure the speed control
lever is set to the OFF/Oposition.
2. Unplug the Stand Mixer or
disconnect power.
3. Loosen the attachment
knob by turning it
counterclockwise, then flip up
the hinged hub cover.
4. Insert the attachment shaft
housing into attachment hub.
Make sure attachment power
shaft fits into square attachment
hub socket. It may be necessary
to rotate attachment back and
forth. When the attachment is in
proper position, the pin on the
attachment will fit into the notch
on the hub rim.
5. Tighten the attachment knob
by turning it clockwise until the
attachment is completely secured
to the Stand Mixer.
Removing Attachments
1. Make sure the speed control
lever is set to the OFF/Oposition.
2. Unplug the Stand Mixer or
disconnect power.
3. Loosen the attachment knob
by turning it counterclockwise.
Rotate the attachment back and
forth slightly while pulling it out.
4. Replaceattachment hub cover.
Tighten attachment knob by
turning it clockwise.
Continued on next page