Gas Requirements - Kenmore 11098762790 Owner's Manual And Installation Instructions

H. LEVEL LAUNDRY CENTER I. INSTALL GAS LINE
Leveling your laundry center
properly prevents excessive
noise and vibration.
STEP 1. Tilt laundry center forward
until rear of laundry center is at least
3 inches off floor. You may hear the
self-adjusting rear legs click into place.
Lower laundry center to floor. Check
levelness of the laundry center by
placing a level on top of the washer,
first side-to-side; then front-to-back.
STEP 2. If laundry center is not level,
prop up the front of the laundry center
and adjust the legs up or down as
necessary. Lower laundry center and
reset self-adjusting rear legs (as in
STEP 1). Repeat STEP 2 until the
laundry center is level.
NOTE: Do not tighten the front leg nuts
until after you have connected your
exhaust system (see pages 26-31).
The proper gas connection ensures
a safe installation that meets local
code requirements.
GAS REQUIREMENTS
Explosion Hazard
Use a new AGA approved gas
supply line.
Connect laundry center to a regulated
gas supply with a shut-off valve.
L.P. gas supply pressure must not
exceed 13" water column.
Securely tighten all gas connections.
Failure to follow these instructions
can result in death, explosion, or fire.
It is your responsibility to contact a
qualified gas line installer to ensure
you have natural gas.
• The design of this laundry center has
been certified by the American Gas
Association for use at altitudes up to
2,000 feet above sea level at the B.T.U.
rating indicated on the model/serial
number plate. Burner input adjustments
are not required when the laundry
center is operated up to this level.
• When installed above 2,000 feet,
a four percent (4%) reduction of the
burner B.T.U. rating shown on the
model/serial number plate is required
for each 1,000 foot increase in eleva-
tion. For assistance when converting
to other gas types and/or installing
above 2,000 feet elevation contact
your local service company.
24