Kenmore 11098762790 Owner's Manual And Installation Instructions page 59

Problem Possible Cause Solution
Not Drying Lint screen is clogged with lint. Clean lint screen.
Satisfactorily Restricted air movement.
Exhaust vent or outside exhaust
hood is clogged with lint.
Run dryer for 5-t0 minutes. Hold
hand under outside exhaust hood to
check air movement. If you do not feel
air moving, clean exhaust system of
lint or replace exhaust vent with rigid or
flexible heavy metal vent
(see "INSTALLATION',' Section J).
Exhaust vent is crushed Replace with rigid or flexible
or kinked, heavy metal vent
(see "INSTALLATION',' Section J).
Gas valve on supply line Open all valves,
is closed,
Timer or the temperature Select the right cycle for the types
control is set on AIR DRY. of garments being dried
(see "OPERATION"),
Fabric softener sheets Use only one softener sheet per load
blocking outlet grill, and only use it once,
Dryer located in room with Move laundry center where it can
temperature below 45°F. operate in ambient air temperatures
above 45°F.
Large amount of moisture Expect longer dry times with items
in the load, that hold more moisture (cottons),
Cold rinse water used, Expect longer dry times, but you are
saving energy and reducing wrinkles,
Load too large and bulky Separate load to tumble freely,
to dry quickly,
Dryer Will Power cord not firmly plugged Plug power cord into a live circuit.
Not Run into a live circuit with proper
voltage,
Fuses blown or circuit Replace fuses or reset breakers,
breakers tripped,
Using a regular fuse, Replace with a time-delay fuse,
Dryer door not firmly closed, Close dryer door tightly,
PUSH TO START DRYER Press PUSH TO START DRYER
Button not firmly pressed, Button again.
Controls not set in an Reset controls in an ON position,
ON position,
59