Kenmore 11098762790 Owner's Manual And Installation Instructions page 26

CONNECT LAUNDRY CENTER
TO GAS LINE
STEP 1. Remove the red cap from
the gas pipe. Move the laundry center
to its final position.
STEP 2. Connect gas supply to laundry
center. Use a wrench to tighten. For
gas connections you must use pipe joint
compound resistant to the action of
L.P. gas. Apply pipe joint compound
to the non-flared male threads only.
There should be a natural loop in the
flexible gas connector. The flexible gas
connector must not be twisted, kinked
or attached with any sharp bends.
STEP 3. Open the shut-off valve in the
supply line. The valve is open when the
handle is parallel to the gas pipe.
VALV _ALVE
STEP 4. Test all the connections by
brushing on a soapy water solution
(liquid detergent also works well).
Bubbles wilt show a leak. Correct
any leak found. Never test for gas
leaks with a flame.
J. CONNECTEXHAUST
CORRECT
tl,
WRONG
WRONG
y
A properly exhausted laundry center
will give you the shortest drying time,
lower your utility bill, and extend the
life of the laundry center.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions
can result in death or fire.
WARNING: To reduce the risk of fire,
this dryer must be exhausted outdoors.
• Use a heavy metal vent.
• Do not use a plastic vent.
• Do not use a metal foil vent.
• Do not exhaust laundry center into
a chimney, a wall, a ceiling, or a
concealed space of a building.
• The diameter of the heavy metal vent
must be 4 inches.
26