Installation Requirements; Tools And Parts; Location Requirements - Kenmore W10110903 Use And Care Manual

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Required
Measuring tape
Level

Location Requirements

The work surface can be installed on top of a front-loading
washer and dryer pair situated next to each other. The washer
and dryer must be level side to side and front to back and at the
same height. Proper installation is your responsibility.
Installation Spacing
The work surface will fit on top of a washer and dryer that are
each 27" (68.6 cm) wide and have a spacing of approximately
1" (2.5 cm) between them for the alignment pads.
2

INSTALLATION REQUIREMENTS

1"
(2.5 cm)
Work Surface Dimensions
3"
(7.6 cm)
25"
(63.5 cm)
NOTE: The work surface will add 3" (7.6 cm) to the overall height
of your washer and dryer.
Front edge
³⁄₈
27 "
(69.5 cm)
Bottom view
A. Alignment pads
B. Side pads
½
56 "
(143.5 cm)
Top view
³⁄₈
27 "
(69.5 cm)
1"
(2.5 cm)
1"
(2.5 cm)
Back edge
A
B