Kenmore 11098762790 Owner's Manual And Installation Instructions page 44

END-OF-CYCLE SIGNAL CONTROL SOFT-HEAT®SYSTEM
Your dryer sounds a signal when
a drying cycle is finished.
The signal is helpful when you are drying
permanent press, synthetics, and other
items. These items should be removed
from the dryer as soon as it stops in
order to prevent wrinkles.
END OF CYCLE SIGNAL
SIGNAL SIGNAL
OFF • _ ON
SOFT-HEAT ® System guards against
overdrying. This helps your fabrics
retain the natural moisture they need,
prevents static, and reduces pilling -
the formation of small lint-like balls
on the surface of garments. Pilling
is the natural result of washing and
wearing of garments.
Kenmore dryers help prevent overdrying
so you get outstanding fabric care. In the
automatic drying and timed drying cycles,
clothes are dried at the temperature you
selected until the last few minutes of the
cycle. The dryer then switches to low heat.
PUSH TO START DRYER BUTTON
Use this control to start the dryer.
Be sure the dryer door is closed.
Opening the door stops the dryer. It
wilt not start again until you close the
door and press the PUSH TO START
DRYER Button. Be sure the Cycle
Selector Control (Timer) is still on a
dry setting.
PUSH TO
START DRYER
END OF CYCLE SIGNAL
SIGNAL SIGNAL
OFF • e ON
COOL DOWN
Approximately ten minutes before the
end of the automatic drying and timed
drying cycles, clothes are tumbled with-
out heat to help reduce wrinkles and make
clothes more comfortable to handle.
44