Final Steps - Kenmore 11098762790 Owner's Manual And Installation Instructions

REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and will increase your satisfaction
with your Kenmore laundry center.
[] Check electrical requirements.
Be sure you have correct electrical
supply and recommended grounding
method.
[] Check that you have:
• All the tools you started with.
• Removed all packaging materials.
• Removed shipping strap with
three cotter pins.
• Installed all parts listed on
pages 6-11.
[] Check that:
• The laundry center is level.
• The nuts on the front legs are tight.
[] Check that the water faucets are
turned on.
[] Ensure that laundry center is
positioned in its final location. Make
sure vent is not crushed or kinked.
FINAL STEPS
[] Plug the power supply cord into
the grounded outlet or power supply.
[] Turn power supply on.
[] Wipe the interior of the dryer drum
thoroughly with a damp cloth to
remove any dust.
[] Remove the blue protective film on
the console and any tape remaining
on laundry center.
[] Take a few minutes and read the
Operating Instructions (pages 33-44)
to fully understand your new laundry
center.
[]
[]
Start the washer and allow it to
complete the HEAVY DUTY Cycle.
To remove air from the gas line, set
the dryer on a full heat cycle (not the
air cycle) for 20 minutes. After five
minutes, open dryer door. The burner
should have ignited during these five
minutes. If you do not feel heat, turn
the dryer off and WAIT 5 MINUTES.
During these 5 minutes check to be
sure laundry center gas supply valve
is open. Repeat steps above. If
the burner still does not ignite, see
Troubleshooting information on
pages 59-60.
32