Cleaning The Lint Screen - Kenmore 11098762790 Owner's Manual And Installation Instructions

27-inch wide- large capacity laundry center washer - gas dryer
Hide thumbs


Table of Contents
Remove Lint Before Every Load
The tint screen is located in the dryer
door opening. Remove lint before every
toad. A screen blocked by lint can
increase drying time.
To clean:
STEP 1. Pull the lint screen straight up.
• Do not run the dryer with the tint screen
loose, damaged, blocked, or missing.
Doing so can cause overheating and
damage to both the dryer and fabrics.
• Some towels made of synthetic fibers
and natural fibers (polyester and cotton
blends) may shed more tint than other
towels, causing your dryer's tint screen
to fill up faster. Be sure to remove lint
from the tint screen before and after
drying new towels.
Wash Lint Screen As Needed
Laundry detergents and fabric softeners
can cause a residue buildup on the lint
screen. Wash the tint screen with a nylon
brush if it becomes clogged due to a
residue buildup.
To clean:
STEP 1. Wet both sides of lint screen
with hot water.
STEP 2. Roll tint off the screen with your
STEP 2. Wet a nylon brush with hot
fingers. Do not rinse or wash screen to
water and liquid detergent; scrub lint
remove lint. Wet lint is hard to remove,
screen with the brush to remove
residue buildup.
STEP 3. Push the lint screen firmly back
into place.
STEP 3. Rinse screen with hot water.
STEP 4. Thoroughly
dry tint screen
with a clean towel; replace in dryer.


Table of Contents

  Related Manuals for Kenmore 11098762790

This manual is also suitable for:


Table of Contents