Kenmore 11098762790 Owner's Manual And Installation Instructions page 27

• Do not use an exhaust hood with a
magnetic latch.
• If using an existing exhaust system,
disconnect vent from the laundry center
and clean one section at a time until you
reach the exhaust hood. To clean out
lint, you can use the hose attachment
on your vacuum or, use a pole or wire
with a feather duster or rag attached.
ROUTE THE VENT
Typical installations exhaust from the
rear of the laundry center.
Avoid pushing the laundry center tightly
against a walt. This can crush or kink the
vent. Use the straightest path you can,
where possible. Avoid 90 ° turns.
• Make sure exhaust hood is not plugged
with lint. Follow the instructions in this
section to reinstall your vent system.
Rear exhaust installations for standard
offset connections - (see pgs. 29-30)
Rear exhaust installations for offset
connections with close clearances -
(see p. 31)
27