Table of Contents
Advertisement
Installation, cont'd
1
2 3 4 5 6 7 8
1&2
7&8
3&6 4&5
Twisted Wire Pairs
Power input captive screw connector — Connect power input
3
cables to the 2-pole female direct insertion captive screw
connector.
12 VDC
.5A MAX.
-
Power Input Captive Screw
Direct Insertion Connector
Remove power before wiring.
Digital audio output captive screw connector — Connect the
4
digital audio output cables to the 2-pole female direct insertion
captive screw connector.
AUDIO
-
AUDIO
Digital Audio Output
Captive Screw Direct Insertion Connector
Remove power before wiring.
2-4
TP T 15HD 45 and TP T A 45 • Installation
Front Panel Connectors and Indicators
TP T 15HD 45
1
COMPUTER
2
INPUT
Figure 2-2 — Front panel views
Power LED indicator — The LED lights green whenever power
1
is applied.
15-pin HD video input connector — Connect computer video
2
input.
Input only sync signals, no video
signals, on the sync pins, 13 and 14.
For component video, use the R (R-Y)
and R return pins (pins 1 and 6), G
(Y) and G return pins (pins 2 and 7), and B (B-Y) and B
return pins (pins 3 and 8).
For S-video, use the R, R return (C-chroma), G, and G
return (Y-luma) pins.
For composite video, use the G pin and the associated
return pin. For additional genlocked video signals, use
the R, B, and associated return pins.
The TP T 15HD 45 and TP T A 45 are only compatible
with the RGBHV and RGBS VTR series of receivers.
3.5 mm stereo mini jack input — Connect unbalanced audio to
3
this stereo jack. Wire the male plug as shown below.
Input only analog and line level audio signals on this
connector.
Cabling and Setup
To install the TP T 15HD 45 and TP T A 45 models, follow these
steps:
Turn all of the equipment off and, if applicable, disconnect
1
it from the power source.
TP T 15HD 45 and TP T A 45 • Installation
TP T A 45
1
AUDIO
3
INPUT
Tip (L)
Ring (R)
Sleeve ( )
10
5
1
6
15
11
Female
2-5
Advertisement
Table of Contents
