Rear Panel Connectors - Extron electronics TP T 15HD 45 User Manual

Quick Start Guide — TP T 15HD 45 / A 45
Installation and service must be performed by authorized
CAUTION
personnel only. These units must be installed in
accordance with national and local electrical codes.
Step 1
Power off all devices and disconnect them from the power source.
Step 2
Connect the UTP cable from the receiver to the 8-pin connector on
the TP T 15HD 45. To wire the connector, see Rear Panel Connectors
in chapter 2 for the pinout table.
Do not connect the TP T 15HD 45 to a computer data or
CAUTION
telecommunications network.
Step 3
Connect the external power supply to the transmitter.
Step 4
Using the 15-pin front panel HD connector, attach a computer input
to the transmitter and a display output to the receiver. See the
example application diagram below.
Extron
TP R 15HD A
Twisted Pair
Receiver
Ceiling
Projector-mountable
Extron
AUD IO
TP T A 45
INP UT
PUT ER
COM
UT
TP T 15HD 45 INP
Twisted Pair
Transmitters
TP T 15HD 45 and TP T A 45 • Quick Start Guide
Projector
Mounting
Bracket
Mounting
Bolt
CAT 5/6 or
Extron
Skew-Free TM
UTP Cable
Up to 500 feet
QS-1