Rear Panel Connectors - Extron electronics TP T 15HD 45 User Manual

Installation
Installation, cont'd

Rear Panel Connectors

TP T 15HD 45
TP T 15HD 45
12 VDC
1a .5A MAX.
AUDIO
1b
AUDIO
Figure 2-1 — Rear panel views
Power input captive screw connector — Connect the included
1a
12 VDC external power supply to the 2-pole female direct
insertion captive screw connector.
The TP T 15HD 45 and the TP T A 45 share a single
power supply. Neither one can be remotely powered by
the attached receiver.
A A
SECTION A–A
Power Supply
Output Cord
The two power supply leads must be kept separated
while the power supply is plugged into an electrical
outlet. Remove power before wiring.
Power supply voltage polarity is critical. Incorrect
CAUTION
voltage polarity can damage the power supply and
the transmitter. Identify the power cord negative
lead by the ridges on the side of the cord.
When stripping the wire ends, please note that
stripped wire ends that are too short may pull out
from the captive screw connector and stripped wire
ends that are too long could possibly touch and
short together.
Captive screw digital audio input connector — Connect the
1b
digital audio input cables from the TP T A 45 (if installed) to the
2-pole female direct insertion captive screw connector.
2-2 TP T 15HD 45 and TP T A 45 • Installation
TP T A 45
TP T A 45
AUDIO
4
AUDIO
12 VDC
3
2 .5A MAX.
12 VDC
.5A MAX.
Captive Screw
Direct Insertion Connector
AUDIO
- -
AUDIO
Digital Audio Input Captive Screw
Direct Insertion Connector
Remove power before wiring.
The wire gauge should be 14 -22 AWG and the
maximum distance between the modules should not
exceed 25 feet.
Video and audio output 8-pin spring force connector — Attach
2
a UTP cable from a TP receiver to the 8-pin spring force
connector. Wire this connector according to the following pin
assignment table.
Twisted Pair Pin Assignments
TIA/EIA T-568-A
Pin Signal
Wire Color
1
red / vertical sync + white-green
red / vertical sync - green
2
digital audio + white-orange
3
green + blue
4
green - white-blue
5
digital audio - orange
6
blue / horizontal sync + white-brown
7
blue / horizontal sync - brown
8
T-568-A is recommended when using Extron Enhanced
Skew-Free™ A/V UTP cable.
Do not connect the transmitter to a computer data
CAUTION
or telecommunications network.
Using the included tweeker tool and observing the correct
wiring colors in the previous table, insert the stripped wire ends
(see note below) of the twisted pairs into the spring force
connector, as shown in the following diagram.
Strip approximately 0.43" (1.1 cm) of insulation from
each individual wire on one end of a TP cable.
TP T 15HD 45 and TP T A 45 • Installation
TIA/EIA T-568-B
Wire Color
white-orange
orange
white-green
blue
white-blue
green
white-brown
brown
2-3