Care And Cleaning; Beater To Bowlclearance - KitchenAid K45SSWH Instructions And Recipes Manual

Oare And Oleaning
Injury Hazard
Unplug mixer before inserting
or removing beaters.
Unplug mixer before cleaning.
Failure to do so can result in
broken bones or cuts.
Bowl, fiat beater and dough hook may
be washed in all automatic dishwasher.
Or, clean them thoroughly in hot stldsy
water and rinse completely before
dl\¥ing. Wire whip should be hand
washed and dried immediately. Do not
wash wire whip in a dishwasher.
NOTE:
Always
be sure
to unphlg
mixer before cleaning. Wipe mixer
with a soft, damp cloth. Do not use
commercial cleaners. Do not immerse
ill water. Wipe off beater shaft
flequently, removing any residue that
may accumulate.
Beater To BowlClearance
Your mixer is adjusted at the factory so that the fiat beaterjust clears the bottom of
the bowl. If for any reason, the flat beater hits the bottom of the bowl or is too far
away fl'om the bowl, clearance call be corrected as follows:
4% QUART MODELS
* Unplng mixer.
* Lift
motor
head.
* Turn screw (A)
SLIGHTLY
counter clockwise
(left) to raise flat beater or clockwise (right) to -- A
lower flat beater.
" Make adjustnlent with flat heater, so it just clears
surface of howl.
NOTE:
If yon over adjust the screw, the bowl lock
lever may not lock into place.
5 QUART MODELS c:
" gnplng mixer. : _
" Place howl lift handle ill down position.
, Turnscrew(B)SLIGHTLY counterclockwise
(left) to raise fiat beater and clockwise (right) to U;; , ,%
lower flat heater.
\,
* Make adjustnlents with flat heater, so it just clears
surface of howl.
NOTE:
When properly adjusted, the fiat beater will not strike oil bottom or side of
bowl. If beater or wire whip is adjusted too close so that it strikes bottom of bowl,
coating may wear off beater or wires may wear through on wire whip.
13