KitchenAid K45SSWH Instructions And Recipes Manual page 13

Assembling Y our 4/Quart Mixer
OFF ON
TO ATTACH BOWL
1. Be sure speed control is
OFF
and
mixer is unplugged.
2. Tilt motor head back.
3. Place bowl on bowl clamping plate.
4. Turn bowl gently in clockwise
direction.
,5. Plug mixer in proper electrical outlet.**
TO REMOVE BOWL
1. Be
sure speed control is
OFF
and
mixer is unplugged.
2. Tilt motor head back.
3. Turn howl in counterclockwise
direction.
Injury Hazard
Unplug mixer before inserting
or removing beaters.
Unplug mixer before cleaning.
Failure to do so can result in
broken bones or cuts.
4. Turn beater to
right, hooking
beater over pin
on shaft.
5. Plug mixer in proper electrical outlet.**
TO REMOVE FLAT BEATER,
WIRE WHIP OR DOUGH HOOK
1. Turn speed control to
OFF
and
tlnplug.
2. Press beater upward as far as
possible and ttlrn left.
3. Pull beater fi'om beater shaft.
4. Plug mixer in proper elecnical outlet.*_
TO LOCKMOTOR HEAD
1. Make sure motor head is completely
down.
2. Place locking lever in
LOCK
position.
3. Before mixing, test lock by
attempting to raise head.
TO UNLOCKMOTOR HEAD
1. Place lever in
UNLOCK
position.
NOTE:
Motor head should always
be kept in
LOCK position
when
using mixer.
TO ATTACHFLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
1.Turn
speed control to
OFF
and
unplug.
2. Raise inotor head.
3. Slip heater onto heater shaft and
press upward as far as possible.
** See page
6.
11
TO OPERATE SPEED CONTROL
Plug mixer in proper electrical outlet.**
Speed control lever should always be set
on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingedients out of bowl.
See page
14
for Speed Control Guide.