Tilt-Head Stand Mixer Use; Care And Cleaning; Beater To Bowl Clearance - KitchenAid Artisan Series Owner's Manual

ilii i ll:i i" _', .....
//]×I I US!
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts or bruises.
NOTE: Do not scrape the bowl
while the Stand Mixer is operating.
The bowl and beater are designed
to provide thorough mixing
without frequent scraping.
Scraping the bowl once or twice
during mixing is usually sufficient.
Turn the unit off before scraping.
The Stand Mixer may warm up
during use. Under heavy load with
extended mixing time, you may not be able to comfortably touch the top of
the unit. This is normal.
/. l'.m];:: {JILL i .i
Bowl, white flat beater and white dough hook may be washed in an
automatic dishwasher. Or, clean them thoroughly in hot sudsy water and
rinse completely before drying. Wire whip should be hand washed and
dried immediately. Do not wash the wire whip in a dishwasher. Do not store
the beaters on the shaft.
NOTE: Always be sure to unplug the Stand Mixer before cleaning. Wipe the
Stand Mixer with a soft, damp cloth. Do not use household or commercial
cleaners. Do not immerse in water. Wipe off the beater shaft frequently,
removing any residue that may accumulate.
I iC I C:WL {:;_Ll.7i:i:-mi(71....
Your Stand Mixer is adjusted at the factory so the flat beater just clears the
bottom of the bowl. If, for any reason, the flat beater hits the bottom of the
bowl or is too far away from the bowl, you can correct the clearance easily.
I Turn speed control to OFf
2. Unplug stand mixer or
disconnect powen
:/ Tilt motor head back.
4 Turn screw (A) SLIGHTLYcounter
clockwise (left) to raise the flat
beater or clockwise (right) to
lower the flat beaten
Make adjustment so that the flat
beater just clears the surface of
the bowl. If you over adjust the
screw, you may not be able to lock
the motor head when it is lowered.
A
NOTE: When properly adjusted, the flat beater will not strike the bottom
or side of the bowl. If the flat beater or the wire whip is adjusted so that it
strikes the bowl, the coating may wear off the beater, or the wires on the
whip may wear.