External Ac Power Supply; Power Connector Location On Rear Panel - Patton electronics IpLink 2884 Getting Started Manual

IpLink 2884 Getting Started Guide

External AC Power Supply.

WARNING CAUTION
1. Insert the barrel type connector end of the AC power cord into the external power supply connector (see
figure 7).
2. Insert the female end of the power cord into the internal power supply connector.
Power
3. Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to chapter 5, "Contacting Patton for assistance"
patible power cord.
4. Connect the male end of the power cord to an appropriate power outlet.
5. Verify that the green Power LED is lit (see
Installing the IpLink 2884
Do not connect power to the AC Mains at this time.
•
The external power adapter shall be a listed Limited Power
•
Source.
The 2884 external power supply automatically adjusts to
•
accept an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
T1/E1
Ports 0-3
ETH 0
10/100/1000Base-T port
ETH 1
10/100/1000Base-T port
Figure 7. Power connector location on rear panel
figure
Console
RESET
RS-232 port
button
on page 32 to find out how to replace it with a com-
6).
3 • IpLink installation
26