Status Error Screens - Outback Power Systems EXTREME OBX-IC2024S-120 Owner's Manual

Status Error Screens

STATUS/FX/PAGE1-------------------
choose category:
MODES METER BATT
STATUS/FX/ERROR-----------P00
low ac output
voltage
DOWN STATUS
STATUS/FX/ERROR----------P00
low battery
voltage
DOWN UP TOP
STATUS/FX/ERROR----------P00
ac output
shorted
DOWN UP TOP
ERROR Screens
All screens read status as "No" under normal conditions. If the unit shuts off due to a specified error condition, that
screen will change to "Yes".
• low ac output voltage: load too high; Inverter could not supply enough AC voltage to meet demand
• stacking error detected: communication problem among stacked units
• inverter overtemp: Inverter has reached its maximum allowed operating temperature
• low battery voltage: battery voltage is below the LOW BATTERY CUT-OUT VOLTAGE set point
(This error can be triggered by other events. It can trigger with low AC output or AC shorted.)
• phase loss error: not active in the OBX-IC2024S-120/60 Inverter
• high battery voltage: battery voltage rose above the safe high battery voltage level for 10 seconds
• ac output shorted: Inverter reached its maximum current and shut down
• ac output backfeed: usually indicates another AC power source was connected to the Inverter's AC output
These are hard faults. The Inverter must be turned off and then on to reset. ERROR screens can only display errors;
they do not offer any means to correct them. Generally the nature of the error suggests how to correct it.
STATUS/FX/PAGE2-------------------
choose category:
PG1 ERROR WARN
PG2
STATUS/FX/ERROR----------P00
No
stacking
error detected
PORT DOWN UP
STATUS/FX/ERROR----------P00
No phase loss
error
PORT DOWN UP
STATUS/FX/ERROR----------P00
No ac output
backfeed
PORT DOWN UP
Pressing the <PG2> soft key brings
up more STATUS categories.
Pressing the <ERROR> soft key
brings up the first ERROR screen.
PG3
Pressing the <DOWN> soft key
brings up successive METER screens.
STATUS/FX/ERROR----------P00
No inverter
overtemp
DOWN
TOP PORT
STATUS/FX/ERROR----------P00
No high battery
voltage
TOP PORT DOWN
STATUS/FX/ERROR------------------
end of error menu
TOP PORT
Push <TOP> to
return to the first
ERROR screen.
No
UP TOP PORT
No
UP TOP PORT
UP TOP STATUS
Push <STATUS> to
return to the "choose
category" STATUS /
screen.
FX/PAGE2
29