Ink Film - Sagem Phonefax 2840 User Manual

Power supply

Ink film

You cannot receive or copy documents unless an
ink fi lm is loaded in the fax machine. The ma-
chine is therefore supplied complete with a free
ink fi lm for a few trial pages.
The symbols áéíó indicate how much ink
fi lm has already been used.
The consumption and print setting are stored on
the supplied Plug'n'Print card. A new card there-
fore must be inserted with each new ink fi lm. The
settings were made at the factory for the initial
free ink fi lm. Therefore only this ink fi lm will work
without a Plug'n'Print card. If the Plug'n'Print
card is missing or if it is not replaced the mes-
sage CHANGE CARD appears on the display.
If the ink fi lm is fi nished or if there is no
ink fi lm in the fax machine, the red display
lamp fl ashes, and the following message ap-
pears:
1 Before loading a new ink fi lm you must re-
move the paper from the paper feed mecha-
nism! To insert the ink fi lm follow the instruc-
tions on your ink fi lm packaging!
2 Open the fax machine by lifting the operating
panel in the middle until it clicks in place.
v For use with SAGEM ink fi lms only!
REFILL INKFILM.
Removing the ink film
1 Lift the rear ink fi lm roll holding both sides
with your index fi ngers upwards, in order to
remove it out of its seat and place it next to
the front ink fi lm roll.
2 Remove both ink fi lm rolls. They cannot be
reused.
3 Remove the old Plug'n'Print card from the
slot to the left of the ink fi lm compartment
(only the initial free ink fi lm does not have a
Plug'n'Print card).
Loading the ink film
1 Carefully remove the rubber rings from the
new ink fi lm. Take care not to damage the ink
fi lm.
7