Easylink - Sagem PHONEFAX 39 TDS User Manual

If a call had been received during your absence or
while you were on a phone call, the symbol I will
appear on the display of your fax machine. The
telephone numbers of the last ten received calls
are stored.
1 Press L on your fax machine for two sec-
onds.
2 Using u you can now step through the
entries. The new entries are marked with an
"*".
3 To call back the displayed number just press
( on the cordless handset.
To delete an entry press C. Choose with
u and confi rm deletion by pressing OK.
If you set FAX RINGS: with M, 31
or 32 to 0, then the telephone number
cannot be displayed on your external tel-
ephones.

Easylink

Using additional telephones
Your fax machine is equipped with a cordless
handset. You can also connect further telephones
to the same telephone line (see Installation /
Additional devices). However, the additional
phone must be set to dual-tone multi-frequency
method. If your telephone connection requires
the pulse dialling method, then you would need
to briefl y reset your additional device to use it.
For more information about this, please see the
user manual for your device.
There are various codes that allow you to transfer
calls or faxes between the cordless handset, fax
machine and other phones. They are shown in
the table below.
To change codes *5 and ** below, call up
function 34 on the fax machine.
v Only use this function when absolutely
necessary!
If you need to change the predefi ned codes, se-
lect function 34 on the fax machine by pressing
M, 34 and OK. Enter two different codes and
confi rm each code with OK. Each code should
begin with * or #.
Please note that the three Easylink codes must
be different. Otherwise on the display ap-
pears:
CODE not OK
19