Craftsman ZTS 7500 Operator's Manual page 8

Figure
3. install Bag and Cover Support
A. Upright Support
B. Bag and Cover Support
C. Support Mount
D. Mount Pin
E. Retainer Spring
F. Shoulder Rest
G. Shoulder Bolt
Cover and Bag Support hstaHation
NOTE." The Support Mount Pin and Retainer Spring are
attached to the Bag and Cover Support at the factory.
The Mount Pin and Retainer Spring must be removed
from the Bag and Cover Support to attach the Bag and
Cover Support to the Upright Support.
t, Attach the bag and cover support (B, Figure 3) to the
upright support (A) by sliding the support mount (C)
over the upright support (A) until the shoulder rest (F)
makes full contact with the shoulder bolts (G),
2, insert mount pin (D) through the support mount (C)
and upright support (A) as shown,
3, Secure mount pin (D) with retainer spring (E),
Figure 4. Cover installation
A. Cover AeeemMy
B. Bag Support Bracket
C. Cover Hinge Pivots
D. Hinge Pine
E. Retainer Springs
hstaH cover
NOTE: The Hinge Pins and Retainer Springs are
attached to the Bag and Cover Support at the factory.
The Hinge Pins and Retainer Springs must be
removed from the Bag and Cover Support to attach
the Cover Assembly to the Bag and Cover Support.
1. Attach cover assembly (A, Figure 4) to bag support
bracket (B) using cover hinge pivots (C). Secure
cover assembly to bag support bracket using hinge
pins (D) and retainer springs (E) as shown.