Table of Contents
Advertisement
•
Never use a battery that has t_en
dropped or re-
ceived a sharp blow. A damaged
battery is subject to
explosion,
Properly dispose
of a dropped
battery
immediately.
Failure to heed this warning can result in
serious personal Injury.
•
Before using
battery charger,
read all instructions
and cautionary
markings
In this manual,
on
battery
charger,
and product using batteW
charger.
Following this rule will reduce the rtsk of
electric shock, fire, or serious personal InJun/.
•
To reduce risk of injury, charge only nickel-
cadmium
and nickel
metal hydride type recharge-
able batteries.
Other typos of batteries may burst
causing
personal
Injury end damage.
Following this
rule will reduce the risk of electric shock, fire, or
serious personal Injury.
•
Do not expose charger to rain or snow. Following
this rule will reduce the risk of electric shock, fire, or
serious personal injury.
•
Use of an attachment
not recommended
or sold
by the battery charger
manufacturer
may result in
a risk of fire, electric
shock, or injury to persons.
Following this rule will reduce the risk of electric
shock, fire, or serious persona] injury,
•
TO reduce risk of damage to charger body and
cord, pull by charger
plug rather than cord when
disconnecting
charger.
Following this rule will
reduce the risk of electric shock, firs, or sedous
persona] Injury.
•
Make sure cord is located so that it will not he
stepped on, tdpped over, or otherwise
subjected
to damage
or stress. Following this rule will reduce
the risk of serious personal Injury.
•
An extension
cord should not be used unless
absolutely
necessary.
Use of improper extension
cord could result In a risk of fire and electric shock. If
extension
cord must be used, make sure:
a. That pins on plug of extension cord am the
same number, size and shape as those of
plug on charger.
b. That extension
cord is properly wired and In
good electrical condition; and
c. That wire size Is large enough for AC ampere
rating of charger as specified below:
Cord Length (Feat)
25'
50'
100'
Cord Size (AWG)
16
16
16
Note; AWG = American
Wire Gage
•
DO not operate charger with a damaged cord or
plug. If damaged, have replaced Immediately by a
qualIfied serviceman.
Following this rule will reduce the
risk of electric shock, fire, or sedous personal Injury.
•
Do not operate charger
If It has received
a sharp
blow, been dropped,
or otherwise
damaged in any
way; take It to a qualified serviceman.
FolloNing
this rule will reduce the risk of electric shock, fire, or
serious personal Injury,
•
Do not dleaiaemble
charger; take It to a qualIfied
serviceman
when service or repair is required.
Incorrect
reaseembly
may result in a dsk of
electric shock or fire. Following this rule will reduce
the risk of electric shock, fire, or serious personal
injury.
•
To reduce the dsk of electric shock, unplug
charger from outlet before attempting
any mainte-
nance or cleenlng. Turning off controls
will not
reduce this risk. Following this rule will reduce the
risk of electdc shock, fire, or serious personal injury.
[]
Do not use charger
outdoors.
Following this rule will
reduce the risk of electric shock, fire, or serious
personal injury.
•
Disconnect
charger from power supply when not
in use. Follow[ng this rule will reduce the risk of
electdc shock, fire, or sedous personal Injury.
•
RISK OF ELECTRIC SHOCK. DO NOT TOUCH
UNINSULATED PORTION OF OUTPUT CONNEC-
TOR OR UNINSULATED BA'I-FERY TERMINAL,
Save these Instructions.
Refer to them frequently
and use them to instruct others who may use this
tool. If you loan someone
this tool, loan them
these instructions
also. Following this rule will
reduce the risk of electric shock, fire, or serious
personal Injury.
j_ WARNING:
Some dust created by power sanding,
sawing, grinding, drilling,
and other construction
activities
contains
chemicals
known to cause
cancer,
birth defects or other reproductive
harm.
Some examples
of these chemicals
are:
• leed from lead-based
paints,
• crystalline
silica from bricks and cement
and other masonry
products,
and
• arsenic
and chromium from chemically-
treated
lumber,
Your risk from these exposures
varies,
depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated
area, and work with approved
safety
equipment, such as those dust masks that are
specially designed
to filter out microscopic
particles,
Advertisement
Table of Contents
