Assembly; Checking Table Insert - Craftsman 113.29570 Owner's Manual

X Lockwasher, 5 /16 in. ExternalType
(approx.dia. of hole5/16 in.) ............... 4
X Luckwashar-#10 ExternalType
(approx.die. of hole3/18 in.) ............... 2
Y WingScrew, 1/4-20 x 1/2 {n.long ............. 2
Z Rex Hd. Screw, 5/16 - 18 x 1-1/2 im long ....... 2
Z Hex Hd, Screw,5/16 - f8 x 1 in. tong .......... 2
AA Screw,Pro1 Hd. 10-32 x 3/4 .................. 2
The following parts are included with Model 113.295750
Key
No. Part Name Qty.
A Leg . .................................... 4
B Side Stiffener ............................. 2
C End Stiffener ............................. 2
I1 Table Extension ........................... 2
Pkg.of Misce!laneous S mall Parts,No. 62659
Consistingof the Following:
E Hex HeadScrew5/16--18 x 1-1/4 in. long ..... 6
F Lockwashsr,1/4 in. ExternalType
(appmx. dia, of hole1/4 in.) .............. 24
F Leckwasher, 5/16 in. ExternalType
(approx.dia. of hole 5/16 in.) ............. 6
G HexNut, 1/4-20
(approx.dia. of hole1/4 in.) .............. 24
G HexNut, 5/16-]8
(approx.die. of hole5/16 in.) ............. S
G Hex Nut, 1/2-13
(approx, die. af hole1/2 in.) .............. 8
III
B
D
H FlatWasher(dia, of hole, 11/32 in.) .......... 6
J TrussHeadScrew,1/4-20 x 5/8 in. long
(top of screwis rounded) ................. 24
K LevelingFoot ..... . ..................... 4
ASSEMBLY
Before mounting the saw on legs, a stand or a bench, the
Table Insert and Blade Squareness and Blade Elevation
must be checked at this time,
INSTALLING ELEVATION AND TILT HANDWHEELS
1. Line up FLAT SPOTS on shaft and handwheel, push
handwhee] onto shaft, Install screw and Iockwasber to
lock handwheel on shaft.
LOCKWASHER
T
SCREW
TILT HANDWHEEL
CHECKING TABLEINSERT
I, With the insert in place, and sawblade all the way down,
use a small scale or straight edge to check near each of
the eight leveling tab positions, in order to determine if
the insert is flush with saw table surface at all eight tab
locations.
2. If the insert is above the table surface, the leveling tabs
must be adjusted.
A. Loosen Screw.
B. Lift insert from front end, and pull toward front of
sew,
C. Remove the insert, place it upside down on your
workbench end GENTLY TAP each of the tabs
downward only a slight amount. Replace insert...
check it and readjust tabs, if necessary.
LOCKWASHER
SCREW
ELEVATION HANDWHEEL
LEVELING TAB
7