Table of Contents
Advertisement
assembly
Before mounting the saw on legs, a stand or a bench, the
Table Insert and Blade Squareness must be checked at
tt_s time.
INSTALUNG
HANDWHEELS
LOCKWASHER
1. Line up FLAT SPOTS on shaft and Handwheel, Push
Handwheelonto shaft. Install screw and Iockwasher
to lock Handwheel on shaft.
10-32 X 314 IN.
/
PHILLIPS
HEAD SCREW
ELEVATION
TI L'F HANDWHEEL
HANDWHEEL
CHECKING
TABLE INSERT
i WARNING:
To avoid Injury lrom accidental _rt,
make sure switch Is "OFF" and plug is not con-
nected to power source outlet.
1. Insert should beflushwithtabletop, Chsck as shown.
Loosen flat head screw that holds inert and adjust the
four set screws as necessary. Tighten flat head
screw.
Do not tighten screw to the point where it
deflects the insert.
CAUTION:
Insert must be even with the table
surface,
inserts too high or low can let the
workplece
"snag" or catch on uneven edges.
Workplece could twist and kick back.
2. To remove Insert
i1
A. Make sure saw is off and unplugged.
B. Loosen Screw.
C. Lift Insert from front end, and pull toward front of
saw.
3. To replace Insert.
A. Make sure saw is off and
unplugged.
B. Place insert into insert opening in table and push
toward rear of saw to engage springclip and until
keyslot in Insert will drop over screw.
Tigl'ten
screw.
C. Do not tighten screw to the point where it will
deflect the Insert.
CHECKING
BLADE SQUARENESS
TO
TABLE
IMPORTANT:
BLADE must be SQUARE (90o)
"¢_
TABLE, in order to proceed with assembly.
1. Make sure saw is off and unplugged.
2. TurnElevation Handwheel clockwise until blade is up
as highas it will go.
3. Check for BLADE SQUARENESS.
ff blade is not
square to table, adjust it at this time.
NOTE: The combination square must be "true" - see
start of *Unpacking and Checking Contents" section
on page 6 for checking method.
Refer to "Blade Tilt, or Squareness of Blade to Table"
adjustment on page 39.
MAKE
SURE
SQUARE
IS NOT
TOUCHING
TIP OF TOOTH
/
/
/
10
Hide quick links:
Advertisement
Table of Contents
