Panasonic Digital Palmcoder PV-DV103 Operating Instructions Manual page 7

• If the Palmcorder is connected to a power
source, the cassette can be inserted and
ejected without turning the Palmcorder on.
1 TAPE EJECT
3PUSH
CLOSE
Compartment
f Cover
• When inserting the cassette, make sure it
is facing the right direction and then push
it in completely.
• If Hand Strap is tight it may prevent
Cassette Holder from fully opening for
Cassette insert or eject. Loosen Hand
Strap if necessary.
iBefore you begin
Connect the Palmcorder to a power
source. (pp. 14, 15)
Slide TAPE EJECT to open the
Cassette Compartment Cover.
Insert a cassette record tab up,
window side facing out.
Press PUSH CLOSE to close the
Cassette Compartment Cover.
° To remove the cassette...
Slide TAPE EJECT to open the Cassette
Compartment Cover and pull the cassette
tape straight out.
Undo the two strap ends from their
buckles.
Adjust the length of the Hand Strap to the
size of your hand as illustrated.
Hand Strap
Reinsert the strap ends through
their buckles.
• Make sure the straps
are not twisted.
Loosen the strap from the Buckle and
create a loop.
Pull the strap firmly through the
Buckle to shorten or lengthen the
strap, tO
Attaching the Lens Cap Strap:
Thread the Lens Cap Strap through the_
Strap Attachment Ring as shown.
Attaching the Lens Cap Strap to the
Hand Strap:
Remove the Hand Strap from the front
clasp and thread the Strap through the loop
in the Lens Cap Strap. Reattach the Hand
Strap.
7