Panasonic Digital Palmcoder PV-DV103 Operating Instructions Manual page 4

Table of Contents

Advertisement

15. Power Lines -- An outside antenna system should
not be located in the vicinity of overhead power lines
or other electric light or power circuits, or where it can
fall into such power lines or circuits. When installing
an outside antenna system, extreme care should be
taken to keep from touching such power lines or
circuits as contact with them might be fatal.
16. Overloading
-- DO not overthad wall outlets and
extension
cords as this can result in a risk of fire or
electric shock.
17. Objects and Liquids -- Never push objects of any
kind into this video unit through openings as they
may touch dangerous
voltage points or short out
parts that could result in a fire or e_ectric shock.
Never spill liquid of any kind onto the video unit.
18. Servicing -- DO not attempt to service this video unit
yourself as opening or removing covers may expose
you to dangerous
voltage or other hazards. Refer all
servicing to qualified service personnel
19. Damage Requiring
Service -- Unplug this video unit
from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
a. When the power-supply
cord or plug is damaged.
b. If any liquid has been spilled into, or objects have
fallen onto, the video unit.
c. If the video unit has been exposed to rain or water.
d. If the video unit does not operate normally by
following the operating instructions.
Adjust only
those controls that are covered by the operating
instructions,
as an improper adjustment
of other
controls may result in damage and will often
require extensive work by a qualified technician to
restore the video unit to its normal operation.
e. If the video unit has been dropped or the cabinet
has been damaged.
f. Whenthevideounitexhthitsadistinctchangein
performance
-- this indicates
a need for service.
20. Replacement
Parts -- When replacement parts are
required, be sure the service technician
has used
replacement
parts specified
by the manufacturer
or
have the same characteristics
as the original part.
Unauthorized
substitutions
may result in fire, electric
shock or other hazards.
21. Safety Check--
Upon completion
of any service or
repairs to this video unit, ask the service technician
to
perform safety checks to determine
that the video
unit is in safe operating order.
USE & LOCATION
• TO AVOID
SHOCK HAZARD
... Your Palmcorder
and power supply should not be exposed to rain or moisture.
DO
not connect the power supply or operate your Palmcorder
if it gets wet. Your Palmcorder
has been designed for
outdoor use, however it is not designed to sustain direct exposure
to water, rain, sleet, snow, sand, dust, or direct
splashing from a pool or even a cup of coffee. This action could permanently
damage the interna_ parts of your
Palmcorder.
DO not attempt to disassemble
this unit. There are no user serviceable
parts inside. Unplug your
Palmcorder
from the power supply before cleaning.
• DO NOT AIM YOUR PALMCORDER
AT THE SUN OR OTHER BRIGHT OBJECTS
• DO NOT LEAVE THE PALMCORDER
WITH THE EVF AIMED DIRECTLY AT THE SUN AS THIS MAY CAUSE
DAMAGE
TO THE INTERNAL
PARTS OF THE EVF
• DO NOT EXPOSE YOUR PALMCORDER
TO EXTENDED
HIGH TEMPERATURE
... Such as, direct sunlight,
inside a closed car, next to a heater, etc... This action could permanently
damage the internal parts of your
Palmcorder.
• AVOID SUDDEN CHANGES
IN TEMPERATURE
... If the unit is suddenly moved from a cold place to a warm
place, moisture may form on the tape and inside the unit.
• DO NOT LEAVE YOUR PALMCORDER
OR THE POWER SUPPLY TURNED ON WHEN NOT IN USE.
• STORAGE
OF YOUR PALMCORDER
... Store and handle your Palmcorder in a manner that will not subject it to
unnecessary
movement (avoid shaking and striking). Your Palmcorder
contains a sensitive pick-up device which
could be damaged by improper handling or storage.
CARE
• TO CLEAN YOUR PALMCORDER
... DO not use strong or abrasive detergents
when cleaning your Palmcorder
body.
• TO PROTECT THE LENS ... DO not touch the surface of the lens with your hand. Use a commercial
Palmcorder
lens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.
• TO PROTECT THE FINISH OF YOUR PALMCORDER
... Before handling your Palmcorder,
make sure your hands
and face are free from any chemical products,
such as suntan lotion, as it may damage the finish.
4

Advertisement

Table of Contents
loading

Table of Contents