Panasonic Digital Palmcoder PV-DV103 Operating Instructions Manual page 45

ISouree (Playing)l
Palmcorder l
-Before you begin
• Connect both Palmcorder and VCR to
their power sources.
• Connect the Palmcerder to a VCR as
illustrated left.
• Turn ON both units.
• Set the recordirlg VCR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER to VCR.
--AN Cable
(Supplied)
Te Audio in
MHF Connecting
Cable (not
supplied)
R_or_Tnng:
_VCR (Rear) 1
Audio In Video In
|r_sert a pre_recorded tape
into the source (playing) Pairncorder
and a blank tape, with record tab in
place, into the target VCR (Recorder).
Press I_ (PLA _t) on the Palmcordef.
When the tape reaches the point you
want to start dubbing, press PAUSE.
Place the VCR into REC/PAUSE
mode. (See VCR manual.)
SimuItaneousiy, press PAUSE On
both units tO begin copying.
Pros STOP on both unite when
copying is completed.
TO Video In
|ili r_J'_ |ll lrl_l | i ilrLiIr( I |Ii
• Turn the TV ON and select its VCR
channel (either OH3 or CH4).
• Set the VCRITV Selector on the
recording VCR to MOR.
• For technical reasons, dubbing a tape
may reduce its quality.
- Press DISPLAY ON TV on the Palmeerder
Remote Control (optional) to eliminate
EVF/LGD Monitor indications
• If the Time Code is displayed in the EVF
or LCD monitor, it cannot be reset.
• Only the DATE!TIME, when displayed, will
be recorded oh the tape.
_cUo CAUTION:
nautherized e._ehanging and;0r !
pying of Copyrighted recordings may J
[be copyright intdngementi J
45