Panasonic Digital Palmcoder PV-DV103 Operating Instructions Manual page 18

Remove the lens cap and clip it to the hand
strap.
(p, Before you begin
Connect the Palmcorder to a power
, source. (+pp.14, _5)
Insert a cassette with the record tab
Set POWER to CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is ful(y turned to the
CAMERA position.
Clip here
RECfPAUSE mode
POWER Lain
15
P(_WER
2wsion
Adiustment
Control
3MENU _
4RECiPAU£E _
WARNING:
• Do not leave the Palmcorder with the
EVF aimed directly at the sun as this
may cause damage to the internal
parts of the EVF.
• Do not lift, or carry, the Palmcorder
by the EVF or the LCD Monitor.
• Do not pull hard on the EVF Eye Cup.
18
With the Viewfinder Eye Cup held up
against your eye, adjust the Vision
Adiustmen_ Corral to your
eyesight.
• Adiust the EVF Brightness of the
View[inder if necessary.
Pleese refer to "To adjust the LCD/
EVF BRIGHTNESS or COLOR' on
page 19.
Set to REC SPEED "SP" or "LP" in
the RECORDING SETUP menu
screen. {Mer_u OSD: p. 65)
Press REC/PAUSE to start recording.
• "REC _ is displayed on the screen.
Press REC/PAUSE aga{n to pause
recording.
Set POWER to OFF when finished.
• To remove the cassette slide TAPE
EJECT.
• When the Palmcorder is aimed at
excessively bright objects, or bright lights,
a vertical bar may _ppear irt the picture.
Thisis a normal characteristic of the CCD
pick-up device. Try to avoid this whenever
possible.
To conserve power
fte_ 5 minutes, the Record/Pause mode
ill automatically change to Standby
ode.
o resume recording, set POWER to
FF and then ON agafn.