Panasonic Digital Palmcoder PV-DV103 Operating Instructions Manual page 44

|_k_lllllll':---- _ ._
dubbed sound.
• When a t6 bit r_c'ording is dubbed eve,',
the odgine( audio of the recording wRI be
erased.
• When a 12 bit recording }sdubbed over
and played back, and MIX is ee_ected as
the AUDIO, both the original aud{o and
the dubbed audio are played back.
, if you receded in LP mode, you cannot
usa the A.DUB feature.
You can set an automatic Dubbing stop
point.
4 Press II (PAUSE) to start Audio
Dubbing. "A.DUB [;>" indication
appears.
• Connect the Palmoorder to the TV in
order to monitor the sound.
(p. 37)
Only NTSC (National Television Standards
Commfttee) recorded tapes _n be audio
dubbed, The following screen appears if
the tape was not recorded in NTSC format,
Press II (PAUSE) to stop Audio
Dubbing.
• If the microphone used for dubbing gets
too near the speaker of your TV,
a howling no{ca (feedback) may occur,
,, If the tape position is inor _8.s started ina
blank section, you cannot use the A.DUE_
f_ature,
44
,the VCR
FUNCTIONS menu sereeh.
B Rotate JOG KEY to select
, and then prees JOG KF..V
Ore display the DISPLAY SETUP menu.
Rotate JOG KEY to select
and then press JOG
to set to MEMORY.
D Press MENU to exit MENU mode.
Then, press RESET on the remote
control to reset the Counter Memory
to M 0:00.00.
Now_ rewind to the editing start paint,
and continue with steps 2-5. The tape wil(
now stop a_omatioally at "M O;00.00_'.