USING THE SIDE BURNER
LIGHTING
INSTRUCTIONS
First remove the cover and any cooking
utensils
from the burner
grate.
Check to see if the burner
cap is on
correct.
Push, turn and hold the control
knob in at the "HI" position
until the burner
is lit or 4 seconds pass
(Fig. 55). If the burner
doesn't
ignite,
wait 5 minutes
for any accumulated
gas to dissipate
then try again.
If the
burner
will not light after several attempts,
check the troubleshooting
instructions
on page 36.
MATCH
LIGHTING
Hold a paper book match near the burner
ports, turn the control
knob counterclockwise
to "HI". Rotate the knob
immediately
once the burner
is lit to the desired
setting.
Note:
If you are using propane
gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been
turned "off". This "extinction
pop" is normal for propane
gas.
29
Fig. 55