HP StorageWorks 8000 - NAS Command Reference Manual page 69

stopClusterNode
Takes a node out of the cluster and transfers all it's running packages to an alternate node.
I
InParam[0] = Node name
getClusterName
Gets the name of the cluster stored in the registry.
I OutParam[0] = Cluster name
setClusterName
Stores the name in the registry. Does not take effect until applyClusterConfiguration
I
InParam[0] = Cluster name
getClusterStatus
Gets status information about the cluster, nodes, and packages.
I
OutParam[0] = A multi-line text string that contains status information about the cluster,
including nodes and packages running on those nodes.
getClusterQsHost
Gets the name of the Quorum server stored in the registry.
I
OutParam[0] = Quorum server name
setClusterQsHost
Stores the name of the Quorum server in the registry. This command is required before executing
applyClusterConfiguration applyClusterConfiguration applyClusterConfiguration applyClusterConfiguration.
I
InParam[0] = Cluster name
getClusterAutoStartEnabled
Gets the AutoStartEnabled AutoStartEnabled value from the registry,
AutoStartEnabled AutoStartEnabled
I
OutParam[0] = T (enabled), or F (disabled)
setClusterAutoStartEnabled
Stores the value in the registry and also updates the cluster configuration to reflect the change. If
enabled, each node will attempt to join the cluster at boot time. If disabled, the cluster must be
started manually using startCluster startCluster startCluster startCluster.
I InParam[0] = T (enabled), or F (disabled)
getClusterNodeNameList
Gets the list of nodes in the cluster.
I OutParam[0:N] = List of node names
setClusterNodeNameList
Stores the list of nodes in the cluster in the registry.
I InParam[0:N] = List of node names
applyClusterConfiguration applyClusterConfiguration is called. applyClusterConfiguration
Command Reference 67