Using Snmp To Monitor The Projector - Epson BrightLink 450Wi User Manual

Using SNMP to Monitor the Projector

Network administrators can use SNMP (Simple Network
Management Protocol) to monitor projectors.
1. Press the button on the remote control, select the
Menu
menu, then press
Network
2. Choose
Network Configuration
3. Choose , then press
Others
4. Turn on the SNMP setting.
5. Enter up to two IP addresses for notification in the Trap IP
Address fields.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
To enter numbers, use the arrow buttons on the remote control to
select each number on the screen, then press the
When you're finished entering an address in the network menu,
highlight , then press the
Finish
6. For
Priority Gateway
return to the previous screen.
.
Enter
and press
Enter
. You see the following screen:
Enter
button.
Enter
, select or
Wired Wireless
note
If you're a network
administrator, you can use
the SNMP option to enter a
trap IP address. This lets you
.
receive trap alerts for the
projectors you're monitoring.
button.
Enter
. Press to
Esc
Using the Projector on a Network
103