Setting Up Your Software - Epson Stylus Pro 9000 Printer Manual

B-2 | Using EPSON Drivers and Utilities for Macintosh
Note
If your Macintosh has a
built-in modem, connect
the interface cable to the
printer port.
3. Connect one end of the interface cable to the serial connector on the
back of the printer.
4. Connect the other end of the interface cable to either the modem port or
printer port on the Macintosh. (Some Macintosh PowerBook
have only one serial port.)
5. Turn on the printer by pressing the
6. Turn on your Macintosh.
See the next section for instructions on installing the printer software. You
must install the printer software before using your printer.

Setting Up Your Software

Before you install the drivers and utilities, you need to make sure your
Macintosh meets the minimum system requirements. Then follow the
procedures for installing the software and selecting the printer. This section
covers:
Checking system requirements
•
Installing the software
•
Selecting your printer in the chooser
•
B-2
button.
Power
® models