3-10
|
Maintaining and Transporting the Printer
Warning
Be careful not to cut
yourself while replacing the
paper cutter blade.
Replacing the Paper Cutter Blade
If you notice that your paper isn't cut cleanly, the cutter blade may need to
be replaced. You can also check the status of your cutter by printing the
status check sheet or using the Printer Status menu on the control panel. See
page 2-3 or 2-4 for instructions.
To obtain a new cutter blade (part number C815131), contact your dealer.
To replace the cutter blade, you first need to remove the used blade, as
described in the following section.
Removing the Used Cutter Blade
Make sure the printer is on, then follow these steps to remove the blade:
1. Press the
SelecType
appears on the display.
MENU
2. Press the
button.
Item
3-10
button repeatedly until
Roll
Cutter Off
CUT. REPLACE=EXEC.
CUTTER REPLACE
Paper Out
SelecType
Paper Source
Roll
Auto Cut
Item
+
appears on the display.