Using The Control Panel To Configure The Printer; Setting Default Roll Paper Margins - Epson Stylus Pro 9000 Printer Manual

2-8 | Monitoring and Configuring the Printer

Using the Control Panel to Configure the Printer

In addition to testing the printer and checking the status of various
components, you can use the SelecType menus to configure printer settings
and perform maintenance operations. The following table lists the menus,
their functions, and where to find additional information:
SelecType menus
Menu Description
Printer Setting Configure the printer
Test Print Print a nozzle check or status check
Printer Status Check ink levels and component life
Paper Register paper thickness and drying time,
Configuration and select registered configurations
Cutter Replace the paper cutter blade
Replacement
Head Alignment Align the print head

Setting Default Roll Paper Margins

The default margins for roll paper are .12 inches or 3 mm (left and right)
and .59 inches or 15 mm (top and bottom). You can use the Printer Settings
menu on the control panel to set the top and bottom margins to 3 mm or set
all margins to 15 mm. Follow these steps:
1. Press the
SelecType
the display.
2. Press the button repeatedly until
Item
appears on the display. This is the default setting.
Press the button once to set all margins to 3 mm.
• +
ROLL MARG=3MM
Press the button again to set all margins to 15 mm.
• +
ROLL MARG=15MM
You can use the
+
2-8
button.
PRINTER SETTING MENU
ROLL MARG=T/B15MM*
appears on the display.
appears on the display.
or button to cycle through all three settings.
–
For more
information
1-13, 1-17,
2-8
2-3
2-4
1-22
3-10
3-3
appears on