Replacing The Paper Cutter Blade; Removing The Old Blade - Epson Stylus Pro 11880 User Manual

132 | Maintaining and Transporting the Printer
Caution: Do not try to
slide the carriage by
hand, or you may damage
the printer.
To run a super strong cleaning cycle, press d to select
•
, then press r to display
CLEANING
cleaning cycle.
To enable roll paper feeding at power-on, press d to select
•
ON ROLL PPR FEED
you want, then press
To return all control panel settings to their default values, press d to
•
select
DEFAULT PANEL
to restore the default settings.
The
• CUSTOM
4. To exit maintenance mode, turn off the printer by pressing the P Power
button. Press the P Power button again to turn on the printer in the
normal operating mode.

Replacing the Paper Cutter Blade

If you notice that your paper isn't being cut cleanly, the cutter blade may
need to be replaced. If you use the blade to cut heavy stock, you will damage
the blade and need to replace it. See page 43 for a list of media that do not
work with the cutter.
You can check the status of your cutter by printing the status check sheet or
viewing its status on the control panel. See page 121 for instructions.
You can obtain a new cutter blade from Epson (part number C12C815291).

Removing the Old Blade

Make sure the printer is on, then follow these steps to remove the blade:
1. Press r .
Menu
2. Press d until
MAINTENANCE
3. Select
CUTTER REPLACEMENT
4. Press the button. The paper cutter holder moves to the replacement
position.
5-132
EXEC
, then press r. Press d to select the setting
to save it.
, then press r to display
setting is for a future enhancement.
is selected, then press r.
, then press r.
SS
. Press to start the
PWR
Press
EXEC.