Power Supply; Charging The Battery - Panasonic DVD Palmcoder VDR-D250 Operating Instructions Manual

Power supply
Power supply
co
When this unit is purchased, the battery is not charged. Charge the battery before using this unit.
• If the DC cable is connected to the AC adaptor, then the battery will not charge. Remove
the DC cable from the AC adaptor.
1 Connect the AC cable to the AC adaptor and the
AC outlet.
2 Put the battery on the battery mount by aligning
the mark, and then securely plug it in.
• The output plug of the AC cable is not completely connected to the
AC adaptor jack. As shown in O, there is a gap.
• Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up
and normal charging will start.
When the battery temperature is excessively high or Iow, the CHARGE lamp flashes and
the charging time will be longer than normal.
• Battery charging time (_. 29)
• We recommend using Panasonic batteries.
• If you use other batteries, we cannot guarantee the
quality of this product.
Push the battery against the battery holder and
slide it until it clicks.
While sliding the BATTERY RELEASE lever, slide
the battery to remove it.
• Hold the battery with your hand so it does not fall.
BATTERY
RELEASE
• Before removing the battery, be sure to set the OFF/
ON switch to OFF and check that the status
indicator is off before removing the battery
LSQT1011