Panasonic DVD Palmcoder VDR-D250 Operating Instructions Manual page 158

Troubleshooting
Cannot register the file
with ImageMixer VCD/
DVD2.
Cannot select this unit as
the write destination
drive with ImageMixer
VCD/DVD2.
The disc for writing is not
recognized by
ImageMixer VCD/DVD2.
The message [There is no
work disk space.] is
displayed and the data
cannot write to disc.
The DISC EJECT lever
does not work when the
unit is connected to the
computer.
When the USB cable is
disconnected, an error
message will appear on
the computer.
• Is there a file with a compatible format in the folder?
Check the help for ImageMixer VCD/DVD2.
• In [Options] in the [Select folder], confirm the small box for
[Add sub-folder(s)] is checked,
• The same folder cannot be selected simultaneously in
DVD-Video mode and Video CD mode. In [Selected
folder(s)] for the mode not being used, delete the folder.
• Cannot write to this unit with ImageMixer VCD/DVD2.
To create a DVD-Video disc, a separate DVD-RW/DVD-R/
+RW/+R drive is required.
• If there is a disc in the drive before ImageMixer VCD/DVD2
is started, the drive will not be recognized properly.
1) Click the upper-right save icon and save the settings.
2) Exit from ImageMixer VCD/DVD2 and remove the disc.
3) Start ImageMixer VCD/DVD2 again, click the [Load
Project] button to read the file with the saved settings.
4) Proceed with [Write to Disc] again.
• There is not enough work space to write to the disc.
Click the [Preferences] button on the upper-right of
ImageMixer VCD/DVD2 and select a work space with a large
amount of free space.
• The DISC EJECT lever does not work after the unit is
connected to the computer. Use the software's eject button
to eject the disc.
• When the drive icon is displayed on the desktop, drag the
icon into the Trash and then disconnect the USB cable.
• When the drive icon is not displayed on the desktop, exit
the application and then disconnect the USB cable.
,=
O
158
LSQT1011