Table of Contents
Advertisement
VCR Sore
amen,
@ wns cD
Power Supply
WUsing the AC Adaptor
1
Connect the DC Input Lead to the [DC IN] Socket on
the Movie Camera.
2 Connect the DC Input Lead to the AC Adaptor.
3
Connect the AC Mains Lead to the AC Adaptor and
the AC mains socket.
The AC Mains Lead's outlet plug cannot be pushed fully into
the AC Adaptor socket. A gap will remain as shown @.
Before connecting or disconnecting the power supply, set the
[VCR/OFF/CAMERA] Switch on the Movie Camera to [OFF]
and make sure that the [POWER} Lamp is not lit.
Wi Using the Battery
Before use, fully charge the Battery.
1 Attach the Battery to AC Adaptor and charge it.
Since the Battery will not be charged when the DC Input Lead
is connected to the AC Adaptor, disconnect them.
@The [POWER] Lamp and [CHARGE] Lamp lights up, and
charging starts.
When the [CHARGE] Lamp goes off, charging is completed.
2 Attach the charged Battery to the Movie Camera.
To Remove the Battery
Set the [VCR/OFF/CAMERA] Switch @ to [OFF], and while
pressing the [BATT RELEASE] Lever 8. slide the Battery to
remove it.
When attaching or removing Battery, set the [VCR/OFF/
CAMERA] Switch to [OFF] and make sure the [POWER] Lamp
is not lit.
WUsing the Car Battery Charger
If you use the Car Battery Charger (VW-KBD2E; optional), you can
supply power to the Movie Camera and charge the battery inside
your car. For further information, refer to the instruction manual of
the Car Battery Charger.
Be sure to start the car engine before you connect the Car Adaptor
Cord, otherwise the fuse may blow.
For other notes concerning this item, see page 42.
Advertisement
Table of Contents
