Table of Contents
Advertisement
Power supply
A battery or the supplied AC adaptor can be used as the power supply for the camera.
f The camera is compatible to following batteries. (As of October 2017)
- AG-VBR59 (supplied/optional, supports quick charging)
- AG-VBR89 (optional, supports quick charging)
- AG-VBR118 (optional, supports quick charging)
- VW-VBD58 (optional)
Charging the battery
The battery is not charged at the time of purchase. Fully charge the battery in the battery charger before using the battery.
It is recommended that you have one extra battery.
f It is recommended to perform charging of the batter in a location with ambient temperature of 10 °C to 30 °C (same for the battery temperature).
f The supplied AC cable is dedicated for this camera. Do not use with any other device. Also, do not use AC cable from other device on this camera.
f The supplied battery charger can simultaneously charge two batteries. Also, it is compatible with the quick charge battery.
1
Connect the DC plug of the AC adaptor to the <DC IN 12V> terminal of the battery charger. (Fig. 1)
2
Connect the AC cable to the AC adaptor. (Fig. 2)
f Insert the AC cable all the way in until it stops.
3
Connect the power plug to the power outlet. (Fig. 2)
4
Mount the battery to the battery charger. (Fig. 3)
The charging lamp of the side the mounted battery will illuminate, and the charging will start.
f Place the battery horizontally along the
f Once the charging is completed, the <CHARGE1>/<CHARGE2> lamp (charging lamp) will turn off. Slide the battery and remove it.
r Display of the <CHARGE1>/<CHARGE2> lamp
The <CHARGE1>/<CHARGE2> lamp (charging lamp) of the supplied battery charger indicates the charging status as follows.
Display of the <CHARGE1>/<CHARGE2> lamp
Green (illuminated)
Orange (illuminated)
Orange (flashing)
Off
@
NOTE
t The battery charger will determine the status of the battery after the battery is mounted. Therefore, it may take some time until the charging lamp is to
illuminate. Mount the battery again if the charging lamp does not illuminate after ten seconds or longer has elapsed.
t When two quick charging compatible batteries are mounted, the quick charging on the <CHARGE1> side will take priority, and the charging on the
<CHARGE2> side will be normal charging. Once the charging of the <CHARGE1> side proceeds, the charging on the <CHARGE2> side will switch to
quick charging.
Also, depending on the charging status of the battery, the indicator on the battery that is mounted on the <CHARGE2> side may turn off.
t The battery charger will perform optimal charging after determining the status of the battery. Once the charging is started, the indicator for quick
charging compatible battery will flash. Also, if it is charging on both <CHARGE1> side and <CHARGE2> side, charging of both batteries will stop when
either one of the battery is mounted/removed, or replaced. It will start the charging again after determining the status of the batteries.
t Mount the battery to be charged prioritized on the <CHARGE1> side when charging.
Chapter 3 Preparation — Power supply
Fig. 1
mark, and slide it.
<CHARGE1>/<CHARGE2> lamp
To the power outlet
Fig. 2
Quick charging
Normal charging
Stopped charging due to an error
Charging is completed or the battery is not mounted
– 30 –
Fig. 3
Charging status
Advertisement
Table of Contents
