Kyocera TASKalfa 250ci Operation Manual page 37

Ready to send.
Place original.
FAX TX Resolution
Select fineness of scanning resolution.
The larger the number, the better the
image resolution.
Place original.
600x600dpi
Original : ---
Zoom : 100%
Paper : ---
200x400dpi
Preview
Super Fine
Add to Addr Book
Status
OPERATION GUIDE
Destination
1
400x400dpi
Ultra Fine
200x200dpi 200x100dpi
Fine Normal
Cancel OK
10/10/2008 10:10
• 200 × 400 dpi (Super Fine): when sending
originals with minute characters and lines
Typical character size: 6 point (example:
)
Resolution
• 400 × 400 dpi (Ultra Fine): when sending
originals with minute characters and lines more
finely
Typical character size: 6 point (example:
)
Resolution
• 600 × 600 dpi (600dpi): when sending originals
with minute characters and lines as finely as
possible
Typical character size: 6 point (example:
)
Resolution
NOTE:
The default setting is 200 × 100 dpi (Normal).
The higher the resolution, the clearer the image.
However, higher resolution also means longer send
times. Normally, up to 400 × 400 dpi (Ultra Fine) is
recommended.
The machine does not support resolution of 300 × 300
dpi when sending faxes. If you have selected 300 × 300
dpi, the machine sends faxes after lowering the
resolution to 200 × 200 dpi (Fine).
The scan resolution should be equal to or higher than
the fax resolution. If the selected resolutions are not in
this condition, the machine automatically adjusts the
resolution and changes the selection.
1 To change the resolution, press [Color/Image
Quality], and then [Scan Resolution].
NOTE:
You can see a preview of the image to be
sent by pressing [Preview]. For details, refer to
Previewing Images on page 3-34.
2 Select the resolution.
3 Press [OK].
FAX Operation (Basic)
Resolution
Resolution
Resolution
3-9
3