6.22
Set Pause After Printing "PZ" 02H 00H 00H m1
Format:
"PZ" 02H 00H 00H m1
Parameters:
Parameter m1 is one byte binary code, and indicates the state as follows:
Set Pause After
Printing
Off
On
Reserved
Function:
-
The default pause state after printing is set.
-
If the pause after printing is ON, the printer is stopped at the pause state after
the FF command is executed.
-
If the auto cutting is set, it is pausing after cutting / printing horizontal lines.
-
If parameter m1 is out of range, this command is ignored and the existing
setting is maintained.
-
This command is only valid in remote mode.
Exception:
-
If the banner mode is set, it processes after the LD command is executed and
not after the FF command.
EPSON Imaging Technology Center
Revision: 1 (Date: 6/20/00)
m1
00H
01H
02H - FFH
Page: 47