Table of Contents
Advertisement
6.20
Set Drying Time "DR" 04H 00H 00H m1 m2 m3
Format:
"DR" 04H 00H 00H m1 m2 m3
Parameters:
The m1, m2 and m3 are each one byte binary parameters. Parameter m1 indicates
the state as follows:
Drying Position
Per scan
Per page
Reserved
The drying time by the following expression is set by the parameters m2 and m3. If
m1=00H(drying per scan), the unit of time is m second. If m1=01H(drying per page),
the unit of time is seconds.
(Drying Time) = ((m3 x256) + m2)
m1=00H: 0
m1=01H: 0
Function:
-
The default environment drying time is set.
-
Stop on the position unit set by m1 for the time set by m2 and m3.
-
If it is per page, it is waiting for setting time after received FF command. (If
the FF command is not received, it doesn't stop.)
-
If parameter m1, m2, and m3 are out of range, this command is ignored and
the existing setting is maintained.
-
This command is only valid in remote mode.
Exception:
-
If the banner mode is set, it processes after the LD command is executed and
not after the FF command.
EPSON Imaging Technology Center
Revision: 1 (Date: 6/20/00)
m1
00H
01H
02H - FFH
(Drying Time) 10000 m seconds
(Drying Time) 3600 seconds
Page: 45
Advertisement
Table of Contents
