Select Graphics Mode "Esc - Epson PM-7000C Programming Manual

6.2 Select Graphics Mode "ESC (G nL nH m"
Format:
ASCII
Hex
Decimal
Range of Definition:
nL=01H, nH=00H
m=01H or 31H
Function:
- Shifts to graphics mode.
- If m has any value other than the above, this command is ignored.
- Printing of lines up to the present line is started, and the printer waits until the
printing is completed.
- The various settings are the same as when the power is turned on.
- The page management coordinate system and the position management
coordinate system are set by taking the printing position in the Y direction at
the time of setting as the origin upon the Y-axis.
- The printing position in the X direction is set to the origin upon the X-axis.
- The MicroWeave print mode selection command is effective.
Initial State:
The character mode.
Related Commands:
Commands related in the direction of applying an effect (Setting)
Commands related in the direction of receiving an effect (Setting)
Commands related in the direction of applying an effect (Operation)
mode:
Commands related in the direction of receiving an effect (Operation)
EPSON Imaging Technology Center
Revision: 1 (Date: 6/20/00)
ESC (
1B 28
27 40
The character mode selection made by the ESC @ command is changed.
The graphics mode is canceled by the ESC @ command.
Only the following commands are valid for Stylus Pro 7000 in Graphics
LF
ESC (U
ESC +
ESC (c
ESC (S
ESC
None
G nL nH
47 nL nH
71 nL nH
ESC (C FF
ESC (V ESC.
ESC (v ESC @
ESC $ ESC (i
ESC U ESC (e
ESC G
m
m
m
CR
ESC (r
ESC H
ESC r
ESC ( /
Page: 23