Table of Contents
Advertisement
6.19
Set Auto Cutting State " AC" 02H 00H 00H m1
Format:
"AC" 02H 00H 00H m1
Parameters:
Parameter m1 is a one byte binary value, and indicates the state as follows:
Set Auto Cutting
Auto Cutting Off
Auto Cutting On
Horizontal print page line On
Blank skip eject mode reset
Blank skip eject mode set
Reserved
Function:
-
The default environment roll paper auto cutting state is set.
-
If the auto cutting is on, the roll paper is cut automatically at TOF position just
after FF command is executed.
-
If the horizontal dot printing is on, it prints horizontal lines at a height of 1 dot
at TOF position just after FF command is executed. (for manual cutting)
-
If the sheet is set, or if it is not stopped at TOF position just after FF command
is executed, it doesn't cut paper / print horizontal line even if it's On.
-
If parameter m1 is out of range, this command is ignored and the existing
setting is maintained.
-
This command is only valid in remote mode.
Exception:
-
When the banner mode is set, it executes the LD Command, then the FF
Command is processed.
EPSON Imaging Technology Center
Revision: 1 (Date: 6/20/00)
m1
00H
01H
02H
40H
41H
03H - FFH
Page: 44
Advertisement
Table of Contents
