Table of Contents
Advertisement
Format:
ASCII
HEX
Decimal
Range of Definition:
nL=04H, nH=00H
0 <= (m4x256x256x256 +m3x256x256 + m2x256 + m1)) x (relative horizontal print
position set unit) inch <= 1FFFFFFFH/1440 inch, or
If bit 7 of m4 is 1, this means that a negative value has been set.
Function:
- The printing position in the X direction is set to a position spaced in the positive
direction from current X direction printing position by (m4 x 256 x 256 x 256
+ m3 x 256 x 256 + m2 x 256 + m1) x (relative horizontal position set unit)
inches. The default value of absolute horizontal position set unit is 1/60 inch
unit.
- If bit 7 of m4 is 1, this means that a negative value is being designated. The
negative value is expressed with 2's complement.
- If the printing position is set by this command to a non-printable region, it is
ignored. However, the printing position can be shifted on the right margin
position.
- This command is effective only for the graphic mode.
Initial State:
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
None
Commands related in the direction of applying an effect (Operation)
None
Commands related in the direction of receiving an effect (Operation)
None
EPSON Imaging Technology Center
Revision: 1 (Date: 6/20/00)
ESC
(
/
1B
28
2F
27
40
47
-
nL
nH
m1
nL
nH
m1
nL
nH
m1
m2
m3
m4
m2
m3
m4
m2
m3
m4
Page: 37
Advertisement
Table of Contents
