The function to print page line of paper size position on the right side and at the bottom of
the paper.
-
If the sheet is selected, the selection of the print page line is invalid.
-
The operation depends on the combination of auto cut On/Off. (See last
paragraph)
-
The default setting of the print page line is Off.
-
The function is available only for printer MicroWeave Mode.
7.5
Paper Saving Function
When paper saving function is selected, the printer follows auto cut setting command (cuts
automatically, prints horizontal lines, and waits) after feeding paper for the bottom margin
at the position received FF (new page) command. As a result, it can save paper if the
image data has space at the end.
When paper saving function is not selected and the printer receives FF command, it
follows auto cut setting command after feeding paper to the position defined with paper
size setting command.
Refer to "AC" command.
7.6
Print Cancel Sequence By Users
When users cancel during printing with the driver, the driver cancels printing to avoid
wasting paper with print cancel sequence.
When the printer receives a print cancel sequence, it follows auto cut setting command
(cuts automatically, prints horizontal lines, and waits) without paper feeding.
Stylus Pro 9000 does not follow this command. However, it works with the same
sequence although it leaves print data a few mm of the roll paper.
Stylus Pro 9000 can avoid leaving print data with print cancel command after transmitting
a few mm set vertical position (ESC ( V, ESC (v ) command.
Refer to command sequence flow.
EPSON Imaging Technology Center
Revision: 1 (Date: 6/20/00)
Page: 55