Set Array; Setting Array Properties - HP StorageWorks MPX200 Solution Manual
Hp storageworks mpx200 multifunction router data migration solution guide (5697-0701, october 2010)
Hide thumbs
Also See for StorageWorks MPX200:
- User manual (282 pages) ,
- Quickspecs (17 pages) ,
- Release note (8 pages)
Table of Contents
Advertisement
set array
Sets the target type of an array to make it behave as either a source, destination, or both.
Session: miguser
Example:
MPX200 <1> (miguser) #> set array
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index
WWPN, PortId
-----
---------------------------------
0
20:78:00:c0:ff:d5:9a:05, 00-00-00
1
50:00:1f:e1:50:0a:e1:49, 82-07-00
2
50:06:01:60:4b:a0:35:de, 82-03-00
3
50:00:1f:e1:50:0a:37:18, 00-00-00
Please select a Target Id from the list above ('q' to quit): 0
Symbolic Name (Max = 128 characters)
Target Type (1=SrcTarget, 2=DstTarget, 3=Src+Dest 4=None Target)
Bandwidth for Migration (0=Array Bandwidth, 50-1600 MBps )
Enable Load Balancing (0=Enable, 1=Disable)
Array based licensed applied.
All attribute values for that have been changed will now be saved.
Setting array properties
Follow these steps to change the array properties using the CLI. Note that all data migration operations
are authorized only to the migration administrator session, miguser. For more information, see
session" on page 73.
1.
Log in to the HP MPX200 router as guest and enter the password.
2.
Open a miguser session using the following command:
miguser start -p migration
(The default password for miguser is migration.)
3.
To access the array properties, enter the following command:
set array
4.
Select a target ID by entering its index number.
5.
At the prompts, modify the symbolic name, target type, or array bandwidth for the source and
destination arrays.
NOTE:
The DM CLI allows you to change the Bandwidth for Migration setting only if the
Target Type is either Source or Src+Dest Target.
Symbolic Name
---------------
HP MSA2012fc-0
HP HSV200-1
DGC RAID-2
HP HSV210-3
MPX200 Multifunction Router Data Migration
Target Type
-----------
Src+Dest
Src+Dest
Src+Dest
Src+Dest
[HP MSA2012fc-0]
[3
]
[0
]
[Enabled ]
"miguser
113
Advertisement
Table of Contents
