Virtual Disk Creation - HP StorageWorks MPX200 Solution Manual

NOTE:
If LUN presentation to the DMS iSCSI initiator is done from Advanced Settings at the time of virtual
disk creation, HP Command View EVA presents the LUN to VPGroup 1 by default. Presenting the
LUN after the virtual disk is created enables you to select the VPGroup.
Figure 23 shows the creation of a virtual disk with HP Command View EVA.
Figure 23 Virtual disk creation
.
Step 2. In HP Command View EVA, present a virtual disk:
1. Click the EVA storage system icon to start the iSCSI storage presentation.
2. Select the DMS Virtual Disk in the Virtual Disk folder.
3. Select the Presentation tab in Vdisk Properties.
4. Click the Present button in Vdisk Properties.
5. Select the DMS iSCSI host entry from the list of hosts.
6. Click the Assign Path button in Vdisk Properties.
7. Select a path in Available iSCSI Controller Paths from the Assign an iSCSI Presentation Path
pull-down menu.
8. Click Present.
IMPORTANT:
Each iSCSI MPX host number under Available iSCSI Controller Paths corresponds to a VPGroup
WWPN on the MPX200. For example, iSCSI MPX Host 04 maps to VPGroup 4.
56 Using DMS for data migration